Products

TTE-CT029

Home > Products > Cable Tester > TTE-CT029
Product Description:
Voltage Detector
The TTE-CT029 is useful for identifying hot and neutral conductors,
finding a break in a wire, and detecting the presence of AC voltage at outlets, switches, circuit breakers,fuses, and wires and cables, including Romex.
Note: Round cords may have twisted conductors, Check for hot
conductors by sliding the unit along the cord.
Note:The TTE-CT029 can be used to find a break in a wire:
To find a break in a hot conductor, trace the wire until the signal stops.
TO find a break in a neutral conductor, connect a load between the hot and neutral.
Trace the wire until the signal stops.
Turn the unit on by rotating the battery cap so that the pointer is in the ON position.
Test the unit in a known live circuit before each use.
If the unit does not function as expected on a known live circuit replace the batteries.
Place the probe tip on or near the circuit or unit to be tested.
Tone and flashing LED indicate the presence of voltage (50 VAC to 1000 VAC)
Note:The voltage detector cannot detect voltage on armored cable;on sheathed nonmetallic cable that is saturated with water; or on cable in conduit, behind panels, or in metallic enclosures.
Packing: Gift box
Product Specification:
Indicators: LED and Tone
Voltage Range:50VAC to 1000VAC
Frequency Range: 50Hz to 500Hz
Measurement Categories:
Category111, 1000 V per UL 61010B-1
CategoryIV, 600 V per IEC 61010-1, 2nd edition
CategoryIII, 1000 V per UL 61010B-1
CategoryIV, 600 V per IEL 61010-1, 2nd edition
Operating Conditions:
Temperature:0°C to 40°C (32°F to 104°F)
Less than 80% relative humidity (noncondensing)
Altitude:2000m (6500')maximum
Indoor use only.
Pollution Degree:2
Bartery:Tw0 1.5 volt batteries (AAA, NEDA 24A or IEC LR03)

Related Products